If your Calgary shrubs have clean, angled cuts on the twigs or bark stripped from the base, rabbits or hares did it, and the damage almost always happens in winter. The fix is a barrier of wire mesh or a guard installed before snow settles, tall enough to clear the snowpack, and a yard that gives rabbits nowhere to hide. Fall is the time to act. A tidy, well-prepared yard is the first half of the job, and it is the part we do every autumn with our fall yard clean up service.
TL;DR
- Rabbit and hare feeding leaves twigs cut cleanly at about a 45° angle, plus stripped bark with tooth grooves near the base.
- Damage peaks in winter, when buds, twigs and bark replace the grass and plants rabbits eat in summer.
- Alberta guidance calls for wire mesh about one metre high, buried at least 15 cm, and tall enough to clear packed snow.
- Put protection up by early to mid-November, check it after heavy snowfall and take it off in spring.
- A shrub chewed all the way around the stem is girdled. Prune below the damage in early spring and let it resprout from the base.
Table of Contents
- How to tell rabbits did the damage
- Why winter is the problem season
- Which shrubs rabbits go for first
- Why girdling is the serious injury
- Protecting shrubs before the snow falls
- A Calgary calendar for rabbit protection
- Make your yard less inviting
- When the damage has already happened
- Our view: a tidy yard is the first defence
- Let us prepare your yard for winter
- FAQ
- Sources
How to tell rabbits did the damage
Start with the cut. Natural Resources Canada says rabbits and hares clip twigs and small branches at a clean 45° angle. Voles leave fuzzier shoots, and deer or moose leave ragged, flat-ended branches. If the end of a twig looks like it was snipped with sharp pruners, suspect a rabbit.
Then look at the bark. On young stems, rabbit gnawing leaves stripped bark with ragged exposed wood. The tooth grooves average about 2 millimetres wide, according to the same federal factsheet. Droppings are another clue: slightly flattened spheres about 10 millimetres across, often found beneath the shrub.

Which animal is it?
Alberta has mountain cottontail rabbits, snowshoe hares, white-tailed jackrabbits and escaped domestic breeds, according to Alberta.ca. Wild rabbits stay grey to brown all year. Hares are grey to brown in summer and turn white in winter. You do not need to tell them apart to protect your plants, because the same barriers work for both.
If the damage is a lawn full of runways and tunnels rather than chewed stems, you are probably dealing with voles. We cover that in our guide to vole damage to lawns in Calgary.
Height tells you something too
Low damage close to the ground suggests rabbits. Snowshoe hares often stand up to clip shrubs up to 45 centimetres above the ground, and as snow deepens they reach higher. In other words, the height of the damage moves up with the snow. A bitten branch two feet off the ground in February may be well within reach of an animal standing on a drift.
Why winter is the problem season
In summer, rabbits and hares mostly eat grasses and forbs. In winter, Alberta.ca explains, they switch to the buds, twigs and bark of shrubs and trees. The same page notes that a hare can eat up to 1 kilogram (2.2 pounds) of green vegetation in a single day, so a small group can strip a hedge quickly once the grass is gone.
Alberta Agriculture adds that gnawing on woody plants can be a direct or contributing cause of plant death. Aggressive pruning to repair damage can also cause undesirable regrowth, which is one reason to be deliberate about repairs.
Population cycles matter as well. Natural Resources Canada reports that snowshoe hare numbers peak every 9 to 11 years, with damage greatest in peak years. Alberta.ca puts the cycle at roughly 10 years and notes that rabbits live only 12 to 15 months, but have about three litters of up to six young in that time. A quiet winter does not guarantee the next one will be.

Which shrubs rabbits go for first
No shrub is completely safe when food is short. Iowa State University Extension notes that when food is scarce and populations are high, nearly all small trees and shrubs are susceptible. Still, some plants get hit first.
| Plant type | Examples named by extension sources |
|---|---|
| Ornamental shrubs | Sumac, rose, dogwood, Japanese barberry, burning bush, flowering quince, some woody members of the pea family |
| Fruit and berry plants | Apple, pear, raspberry, blackberry |
| Small trees | Crabapple, redbud, honey locust, serviceberry |
| Evergreens | Small evergreens, especially pines |
The lists come from Wisconsin Horticulture and Iowa State University Extension. Some of these are cold-hardy choices in Calgary yards, so check your own beds.
Young and thin-barked plants suffer most
Bark character is the main reason. Alberta Agriculture explains that most young trees have smooth, thin bark with green food material just beneath it, while the thick, rough bark of older trees often discourages gnawing. Even on one plant, rabbits avoid rough bark and girdle the smooth young sprouts. New plantings from the last two or three years deserve protection first.
Why girdling is the serious injury
Girdling means the bark is removed in a complete ring around the stem. The University of Vermont Extension explains that this interrupts the tissue that carries water and nutrients from roots to foliage. Damage on one side only can often heal over time. A full ring cannot. All growth above it eventually dies.
This is also why a single hungry night at the base of a young shrub can do more harm than a winter of nibbled tips.
Protecting shrubs before the snow falls
Physical barriers are the most dependable defence. Here is what the official guidance says, and where it goes wrong when people improvise.
Step 1: Choose the right mesh
Alberta.ca recommends wire-mesh fencing with openings smaller than 3.8 cm, standing one metre high with at least 15 cm buried below ground. Alberta Agriculture suggests hardware cloth with 0.6 cm mesh for the most vulnerable plants. Chicken wire works for larger shrubs, but gaps matter: young rabbits squeeze through wider openings.
Step 2: Get the height right
Height is where most home fences fail, because it has to be measured from the snow, not the soil. Alberta.ca advises fencing tall enough that a rabbit cannot reach over it while standing on packed snow. Agriculture and Agri-Food Canada says guards should reach about 50 cm above the expected snowline.
The University of Minnesota Extension warns that even 4-foot fencing was not tall enough to stop rabbit browsing in a record snow year. Calgary can get deep drifts along fences and house walls, so be generous.
Step 3: Close the bottom edge
Rabbits go under as well as over. Alberta.ca puts the buried depth at 15 cm or more. Alberta Agriculture’s figure for poultry mesh and hardware cloth is 7 to 10 cm. Frozen ground makes burying difficult in November, so set it earlier, or pin the edge down with U-shaped anchor pins as Iowa State recommends.
Keep the cylinder at least six inches away from the stem so the animal cannot gnaw through the mesh.
Step 4: Guard the trunks of small trees
For small trees, a white corrugated or spiral guard is the standard choice. The University of Minnesota notes that white guards also help prevent sun scald and frost cracks on thin-barked young trees. Run the guard from the soil line up above the likely snow depth.
Step 5: Consider repellents as a second layer
Alberta Agriculture recommends applying repellents in late fall when leaves have dropped and the bark is dry, at temperatures above freezing, covering every susceptible part up to above the potential snow line. A treatment gives up to one season of protection. Agriculture Canada says to treat the whole tree to two or three feet above the snowline if possible.
If you are planting fruit trees or berry bushes, shelter planning helps too. Good shelter hedges for fruit trees shape how wind and snow move across the plot, and that affects where drifts build up against your protection.
The Calgary Horticultural Society lists softer deterrents for spots where a fence is not practical: garlic planted among crops, pop bottles pushed into the soil so wind makes noise, and waterproof pinwheels that flicker in the breeze. Treat these as extras to a barrier on your most valuable plants.
A Calgary calendar for rabbit protection
Timing is the part homeowners most often miss.
| When | What to do |
|---|---|
| Late September to October | Clear debris and extra cover, cut back overgrown areas, tidy beds |
| Late fall, above freezing | Apply repellent to dry bark if you use it |
| Early to mid-November | Install fences and guards, before winter feeding begins |
| After each heavy snowfall | Check barriers, clear snow if it has built up against or over them |
| April | Remove guards and mesh once snow is gone and winter risk has passed |
The November and April timing comes from Iowa State University Extension. Calgary winters can start earlier than the calendar suggests, so aim for the first half of that window or sooner. Take barriers off in spring. Iowa State warns that a mesh cylinder left on all year can restrict growth or cause girdling.
It is November 11 as we write this. If you have not yet installed anything, do it this week, before the next dump of snow, rather than waiting for a perfect day.
Make your yard less inviting
Barriers protect specific plants. Habitat decides how many rabbits are around in the first place. Alberta Agriculture advises removing non-essential undergrowth and debris that gives rabbits and hares shelter. It also notes that continuous or severe damage may justify switching to less susceptible plant species.
The City of Calgary gives similar advice in its rabbit guidance for residents:
- Do not feed rabbits. Feeding creates a dependency on the food source and disrupts the natural cycle of wildlife.
- Keep garbage in tightly closed, secured bins.
- Keep landscaping tidy, since overgrown grass can provide food and habitat.
- Restrict access to the yard with fencing.
One more note on prunings: Alberta Agriculture says to keep the first six inches… of the plant clear of foliage is a common practice, but the surest approach is to remove brush piles, leaf heaps and tangled dead growth around the base of your shrubs before the snow arrives. That is exactly what a good fall cleanup does. Our guides on fall yard preparation for Calgary homeowners and winter landscape care walk through the full routine.
When the damage has already happened
Start by judging how much bark is gone. Iowa State University Extension says many deciduous shrubs recover by sending up new shoots or suckers from the base, although full recovery can take several years.
- Wait for spring growth. Early spring shows which stems are alive. Prune girdled stems just below the damaged area.
- Look at what bark remains. Partially girdled plants often survive when substantial bark is left. Keep them watered and healthy.
- Skip wound paint. Iowa State states that wound dressings, pruning paints, latex paints and wraps will not repair severe rabbit damage.
- Replace badly girdled trees. For most home gardeners, replacing a fully girdled tree is the best choice, according to the same source.
For a valued tree, the RHS describes repair for partly girdled trunks: pare the rough edges, cover the area with a 4 cm layer of damp moss, wrap with polythene and leave it in place for at least three to four months. Completely girdled trees need bridge grafting, normally done in spring when the cambium is active. Wisconsin Horticulture agrees that sprouting from below the damage or a delicate bridge graft are the only ways to save a fully girdled plant.
Remember that this is advice for rescue. The bigger win is making sure the replacement is protected from its first winter.
Our view: a tidy yard is the first defence
We look after Calgary yards through all four seasons, and we have a simple view of rabbit damage: it is a fall job, not a February emergency.
By the time you see bark stripped from a shrub, the feeding has already happened. What works is a yard prepared before the snow: dead growth and debris cleared away, beds tidy, and the plants that matter most protected. Our fall clean ups are built for that moment, and bed maintenance keeps the ground around shrubs open and easy to inspect.
We also think about the full cycle. A spring clean up gets your yard ready after winter, and winter snow removal means your property is not buried under drifts. Alberta guidance says to size fencing to the snowline, and we are the people clearing that snow, so we know how quickly conditions change from one storm to the next.
Our approach is to treat the property as one system across the year, with flexible service packages and a satisfaction guarantee on every visit. A shrub that survives its first winter is a lot cheaper than one you replace in May.
Lewie
Let us prepare your yard for winter
Our Fall Yard Clean up starts from $95 per service, and it is the natural time to clear the debris and tangled growth that give rabbits cover. If you want the beds around your shrubs kept tidy through the season, we also offer bed maintenance. You can see details and book on our seasonal clean up page.

Once snow arrives, our snow removal plans start from $130 per month, or $30 per one-off service. In the spring, our spring clean up handles what winter left behind.
FAQ
Do rabbits really eat shrubs in Calgary, or is it something else?
Rabbits and hares do, mostly in winter. Look for twigs clipped cleanly at about 45° and stripped bark with 2 mm tooth grooves near the base. Fuzzy or ragged cuts point to voles or larger browsers such as deer.
How high should a rabbit fence be?
Alberta.ca suggests one metre of wire mesh with openings under 3.8 cm and at least 15 cm buried. The key is the snowline: the top must be out of reach of a rabbit standing on packed snow. After a heavy snow year, add more height rather than less.
When should I take the guards off?
Remove fencing and tree guards in spring, typically April, once snow cover is gone and winter feeding risk has passed. Leaving mesh in place all year can restrict growth or cause girdling. Reinstall in early to mid-November.
Will my shrub recover after rabbits chewed it?
Often, yes. If bark remains on part of the stem, the plant can heal. Many deciduous shrubs also resprout from the base, though recovery can take several years. Prune girdled stems below the damage in early spring and avoid wound paints.
Is feeding rabbits ever a good idea?
No. The City of Calgary asks residents not to feed rabbits, because it creates dependency and encourages more animals to gather in your yard and neighbours’ yards. Keep garbage secured and landscaping tidy instead.
Sources
- Rabbit and hare damage, Natural Resources Canada
- Human-wildlife conflict: Rabbits and hares, Alberta.ca
- Rabbits and Hares fact sheet, Alberta Agriculture
- Protecting Trees from Animal Damage, Agriculture and Agri-Food Canada
- How to Protect Trees and Shrubs from Animal Damage Over Winter, Iowa State University Extension
- Winter Damage on Trees, Iowa State University Extension
- Rabbit Ecology and Damage Management, Wisconsin Horticulture
- Winterizing plants: a good fence is the best defense, University of Minnesota Extension
- Winter protection for plants, University of Minnesota Extension
- Winter Pest Management in Apple Trees, University of Vermont Extension
- Ring-barking: Causes and Solutions, RHS
- Wildlife visitors, Calgary Horticultural Society
- What can I do to avoid issues with rabbits? City of Calgary